Our brand new RAM Promaster ladder bolts directly to our new DRIFTR series roof rack. Our ladder has steps that are deeper and flatter than anything on the market, giving you the ability to walk on up and down the ladder barefoot without killing your feet. We also have special notches on the end of each step for extra traction in muddy or wet conditions.

INSTALLATION VIDEO HERE

How to Mount:

Loosely assemble the entire ladder. Pick a good spot where you would like to place the ladder. Make sure the ladder is on the side of the van without the sliding door. Using a friend, hold up the entire ladder and mock it up. Stand far away from the van to see what looks most aesthetically pleasing and mark the holes both at the top of the ladder onto the side of the roof rack and mark the holes underneath the van on the pinch weld. These markings will be where the ladder mounts, so make sure your ladder is straight and aligned properly. After you've verified and marked where the ladder is going to be mounted, drill into the side of the DRIFTR rack and into the pinch weld at the bottom of the van. Install and fasten bolts on the top and bottom of the ladder, then push the middle ladder in or out to set the distance from the van to the ladder and tighten the 4 bolts per side of the ladder. Double check all bolts are tight, and you're good!

Compatible With 2013-current Ram Promaster vans in the 159 and 159 EXT lengths.

WARNING: Some of the products listed contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. None of our products are intended to be used in conjunction with clean drinking water unless stated otherwise. For more info please visit www.p65warnings.ca.gov or contact the Backwoods Adventure Mods sales team.

***THIS PRODUCT IS MADE FOR OFFROAD USE ONLY***